The Kobold SP7 2-in-1 Wet and Dry Attachment is a revolutionary device for vacuuming and washing at the same time, significantly saving time and energy. The 2-in-1 Kobold SP7 attachment washes hard floors extremely effectively.
The VK7 Cleaning System offers a wide range of cloth pads and cleaning products specially formulated to thoroughly clean any type of hard floor.
Before using the Kobold VK7 Cleaning System, check which material overlay is best suited for your surface.
Preparing the material overlay
Detach the fabric overlay frame by pressing the unlocking mechanism, located on the rear left side of the SP7 attachment, with your foot.
To attach the MF7 fabric overlay to the overlay frame, press the overlay portion until it is secured in the groove of the overlay frame.
Lower the 2-in-1 SP7 attachment by placing it over the overlay frame. The overlay frame slides into the Kobold SP7 wash attachment. This is confirmed by a distinctive sound.
Now the device is ready for use.
Preparation of the tank
For wet washing, the fabric overlay can be moistened automatically using the tank of the VK7 washing attachment.
Fill the cap of the tank, which is also a measuring cup, with Koboclean Universal or Koboclean For Parquet Liquid up to the mark (3 ml), and then pour the measured amount into the tank. Add tap water, not exceeding the maximum level marked on the tank.
Enter the tank of the 2-in-1 SP7 attachment.
Using
Turn on the Kobold VK7 vacuum cleaner. The 2-in-1 SP7 attachment can wet the MF7 cloth pad according to three levels of wetting: press the black "+" (located just below the power button) on the vacuum cleaner's swivel handle and hold for 5 seconds to enable full wetting of the cloth pad. Set the desired humidification level with the "+/-" button and proceed with cleaning.